#Set up linksys router manual
#Set up linksys router software
#Set up linksys router password

You should now have successfully set up your Linksys router with DSL Internet connection. Now that you have configured the settings of the router, you can connect the modem to the Internet port of the router using an Ethernet cable. Remember to use the new IP Address of your router (192.168.2.1) the next time you access the router’s web-based setup page. Then type “ipconfig/renew” and press again to refresh the computer’s IP Address. On your computer, open the command prompt then type “ipconfig/release” then press. In this example, the IP Address used is 192.168.2.1.Ĭlick Save Settings and close the router’s web-based setup page. On the Internet Setup section, click the drop-down arrow for Internet Connection Type then select Automatic Configuration – DHCP.Ĭhange the value of the third box in the IP Address field. If you changed the login details, use those details instead. Once you get a login prompt, leave the username blank and enter “admin” for the password. Otherwise, you might end up accessing the modem’s web-based setup page.Īccess the router’s web-based setup page by entering 192.168.1.1 in your browser’s Address bar. NOTE: Make sure the modem is not connected to the router while doing the following steps. To prevent this issue, you can change the router’s IP Address range. Having your modem and router operate as DHCP servers under the same network may cause IP Addressing conflicts. This type of router configuration is ideal for connecting to a modem in Automatic Configuration- DHCP Mode. IMPORTANT: When the router is set up for a PPPoE connection, PPPoE dialers that have been configured on your computers must be disabled.įor Automatic Configuration – DHCP setting Restarting is done by unplugging the power adapter of the router for 30 seconds then plugging it back in. If the Internet IP Address and DNS servers show zeroes (0), you need to restart the router to obtain the correct values. Select Keep Alive and click on the Save Settings button at the bottom of the page.Ĭlick on the Connect button if the Login Status is Disconnected.

#Set up linksys router password

On the Setup tab, click the drop-down arrow for Internet Connection Type then, select PPPoE.Įnter the PPPoE Username and the Password provided by your ISP. Observe the power light of your router until it becomes stable. If your router has a power switch, turn it ON. Plug in the router’s power adapter to a power source and connect the other end to the power port of the router. Setting your preferred Internet Connection TypeĬonnect the computer to one of the Ethernet ports on the router using an Ethernet cable. Follow the instructions below to manually set up your router.

#Set up linksys router manual

Manual configuration of your Linksys router is recommended if the Setup CD failed to set up your router.

#Set up linksys router software

If you lost the Setup CD, you may download the software from the Linksys Support Site.

Simply insert the Setup CD that comes with the device to your computer’s CD drive and follow the on-screen instructions. The software will automatically detect the type of Internet connection from your ISP. The Linksys router comes with a Setup CD for easy installation. Setting up a Linksys router with DSL Internet service You can also contact them if you are uncertain about the type of Internet connection you have. If you cannot access the Internet, contact your Internet Service Provider (ISP). You can do this by connecting your computer to the modem using an Ethernet cable and try browsing any website. What do I need to check Internet before setting up my Linksys router?īefore setting up your Linksys router, make sure that your computer has active Internet connection.